 HomeNewsMicro jet belt notes

Micro jet belt notes

2021-10-30

Note when using microjet tape

1. Before laying the micro-spray belt, it is necessary to remove the pests in the soil with drugs to prevent them from harming crops and biting the micro-spray belt.

2. When laying, the micro-jet belt hole should be upwards and the tail is blocked. Then use a pump to absorb water and extrude. The water inlet is wrapped with gauze (filter screen) to prevent the holes from being blocked. In case of blockage, untie the tail end and rinse it with water for one minute. You can also pat the tube wall gently with your hands and other tools.

3. In the first use, according to your pump pressure, the working length of the micro-spray belt, first open the switch, it is best to open several switches, to prevent the pressure is too large to cause the micro-spray belt blasting. Turn off a few switches if the pressure isn't enough. You'll know how many switches to turn on the next time you use them. If that piece of water is tested, switch on first when changing the piece, and then turn off all the switches of the good piece to prevent blasting caused by improper use.

4. When changing the season, the micro spray belt should be pumped and extruded with water pump, washed, rolled, and put in the shade to prevent rats and other things from biting, so as to be used again next time.

Previous: Labyrinth-type drip irrigation belt installation instructions

Next: Installation method of microjet tape

 HomeNewsMicro jet belt notes

Home

Product

Phone

About Us

Inquiry

We will contact you immediately

Fill in more information so that we can get in touch with you faster

Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.

Name

Mobile Phone

Company Name

Request:

Send